Forum Replies Created
-
AuthorReplies
-
Gerben HaringsmaParticipant
would be most helpfull if one of the members with electronic skills could provide an alternative to this obsolete unit ?,?
anyone please ?
Gerben HaringsmaParticipantbypass is possible,but you will have to remove the dash light,as it will keep burning.
you an pry open the unit and replace the resitor wire,which is probably burned through.
Gerben HaringsmaParticipant[photo 1352]
Gerben HaringsmaParticipantHello Alan,
i did not remove the windscreen.rubber is fine nd probably replaced in the past.
along the chrome trimming,i cut away the rubber ,leaving a wide enough gap to glue the new material.
i intend to reposition the trimming and to fill the gap with a good quality kit, like in my case teck7,
the big problem will be ,to carefully avoid the kit coming on the new fabric,but i think it can be done with good quality painters tap on the fabrick.on the other side, the chrome trimming will give no problem.
will put pictures whenn job done.oo and i will do the whole thing,including the targa pannels,as the material is not that expensive and i donot want clour differences.
Gerben HaringsmaParticipantonly available second hand,but can be repaired!
Gerben HaringsmaParticipantonly available second hand,but cn be repaired!
Gerben HaringsmaParticipantthere was indeed a hole rusted through.and a small one on the right side of the car.
painstakingly cleaned the area,welded and made smooth with lead. sanded and painted.
ready for the final paint and new fabric.
for which we will need the new rubber,or make one ourselves.
problem almost solved.
Gerben HaringsmaParticipant[photo 1336][photo 1337][photo 1341][photo 1338]
Gerben HaringsmaParticipantany update on these rubbers please ??
Gerben HaringsmaParticipanthello Steve,
i face the same problem,but only from time to time.
cold wind only,airco engaged even whenn put at max heat.cured sometimes by sitching engine on and off.
start with the easypart, the vacuum controlled valve at the rear of the cyl.head.( the little round golden bulb.
it should CLOSE whenn asked for heat,and open for cold air.
this part gets spoiled quite often,
you could replace by a plastic valve,doing the same,costs a fraction and lasts longer.
it did not solve my problem yet,will keep you informed on the research.
Gerben HaringsmaParticipantany chance of the targa rubbers being available soon ?
soon: like in april ?
2018 ?
Gerben HaringsmaParticipantthanks Laurence.
Gerben HaringsmaParticipantnice colour Laurence.
did you send my precious part ?
Gerben HaringsmaParticipanti knew you could help me!
please send.. although these rare parts are expensive and transportcosts prohibitive !
therefore only the right hand side one would do..
regards to Christina.
Gerben HaringsmaParticipant[photo 1196]
Gerben HaringsmaParticipantany luck Laurence ?
Gerben HaringsmaParticipantsorry 150
Gerben HaringsmaParticipantthe resistor should be 15 ohm.
Gerben HaringsmaParticipantmysterious car,the jaguar.
the tiny lamp was your resistor ?
Gerben HaringsmaParticipantmystery solved !
a resistor has to be instaled,getting the 5 back to zero.
-
AuthorReplies