This article describes the replacement of the Targa roof and rear hood seals on the XJ-SC Cabriolet. The process involves careful preparation, accurate cutting of new seals, and patient assembly using mitred joints. The guidance below reflects practical experience and is intended to help owners plan and carry out the work methodically.
Lengths of these seals are available for purchase, and can be found advertised in the Club's Forum.
Seal Lengths
The new seal material should be cut to the following minimum lengths:
- 218 cm — A: Main Targa roof hatch sides and front edge
- 119 cm — B: Main Targa roof hatch rear edge (nearest cross-member)
- 71 cm — C: Right-hand
Please log in to continue reading this article.