Fitting the rear hardtop section to the XJ-SC This topic has 1 reply, 2 voices, and was last updated 11 months ago by Simon Spence. This post has been viewed 94 times Viewing 1 reply thread Author Posts 18th June 2021 at 00:23 #17558 Ed WardParticipant Richard Hartwell was good enough to pack up and send me one of his rear hardtop sections recently. The section has 2 toggle clamps, 1 either side to clamp it to the body but there is clearly some extra hardware required. Can anyone advise me where I might locate this hardware and perhaps some replacement clamps. Some advice on how to actually fit the section would also be very much appreciated. Cheers, Ed 22nd June 2021 at 11:40 #17573 Simon SpenceParticipant The blade end ( toggle clmps ) bolts to frame ( Captive nut in frame ) Author Posts Viewing 1 reply thread You must be logged in to reply to this topic. Log In Username: Password: Keep me signed in Log In