[draft] XJ-SC Cabriolet Targa Roof and Rear Hood Seal replacement instructions

This is an outline of what will become a full article in the future on the replacement of seals on the XJ-SC Cabriolet Targa Roof and Rear Hood. There is a discussion thread open also Click Here

These Seals are available in the XJS Soft Tops Club member’s shop The Club Shop.

The lengths of new seal require cutting in to the following lengths (minimum) as follows :

  • 218cm – A – Main Targa Roof hatch sides and front edge
  • 119cm – B – Main Targa Roof hatch rear edge (nearest cross-member)
  • 71cm – C – Right hand side Rear Roof hatch side piece
  • 121cm – D – Rear Roof hatch front edge (nearest cross-member)
  • 71cm – E – Left hand side Rear Roof hatch side piece


> > Please log in Here to continue reading this article < <

If anyone would like to buy replacement seals for their Cabriolet, like those used in this article, please visit the Club Shop – Click Here

Article Published : November 2020
Article written by : Laurence Jones

Scroll Up